Werbung
10
EN
Dear customers,
Thank you for your favour and purchasing of stroller DIXIE PLUS.
SAFETY NOTES
IMPORTANT! Read these instructions carefully before use and keep them future ref-
erence. Your child's safety may be affected if you do not follow these instructions.
WARNINGS! It may be dangerous to leave your child unattended.
WARNING! The seat unit is not suitable for a child younger 6 months.
WARNINGS! Ensure that all the locking devices are engaged before use.
WARNINGS! Any load attached to the handle affects the stability of the pram/
pushchair.
WARNINGS! Always use a harness.
WARNINGS! Do not use if any of the parts is broken, curved or missing.
− accompanying person must be familiar with instructions listed in this manual
− the stroller is designed for child up to 30 kgs
− the brakes must be applied every time when the stroller is not moving
− do not over load the stroller, overloading of a seat, a bag or a basket might cause disruption of the stability of the stroller
− always use the front grab bar and safety 5-point harness
− always pay adequate attention to the ride with a stroller to avoid an accident, which could happen in case of carelessness
− when manipulating with the stroller pay attention to not to harm yourself or a child
− be aware of the road traffic regulations when riding the stroller
− accompanying person has to be aware of fire danger; in buildings obtain the information about allocation of the emergency exit and about the evacua-
tion plan of the building
− use ramp or elevator if possible when overcoming obstacles
− the stroller must be transported by at least two persons
− never transport the stroller when you and your assistant are not sure if you can transport the stroller or portable baby carrier with the child safely
− getting over the curbstone firstly practice with an empty stroller
− do not use the stroller for other purposes then it is designated for
− do not use the stroller for more children than it was constructed for
− do not use any other accessories, which are not approved or supplied by the producer
− when you are assembling the product often, the structure of the stroller might get curved when the guide for assembling of the stroller is breached
− in case of apparent defect, which obstructs the product's safe using (e.g. damage of chassis, part falls away or other optically visible defects, cracks
etc.) it is necessary to stop using the product without delay and contact the dealer.
− company PATRON Bohemia a.s. does not bear the responsibility for the damages caused by using other accessories then supplied by this company
− company PATRON Bohemia a.s. does not bear the responsibility for the damages and accidents caused by inappropriate use of the stroller
INTRUCTIONS FOR USE
Attaching and removing the seat from the chassis
Attaching: Fix the seat onto "clip- and -go " interface from above , pressure
on adapters on each side of the lock . Ensure proper signals by audible click.
Pull the seat up , make sure it is correctly locked ( can not be ejected ) .
Removing : Press both buttons on the outside of the adapter harness ,
pulling upwards remove the seat from the chassis .
WARNING ! Pay attention when carrying the seat !
Abductor block
Seat the child into the stroller and find the appropriate place of the wedge.
Take the child out of the stroller. Find the relevant fitting hole on the seat
base. Place the wedge in the seat (the narrower part should aim to the
backrest) and secure the wedge by a nut.
Headwings
Set the child into the stroller, to determine right height of headwings. Take
the child out of the stroller. Put headwings in determined height onto the
backrest, and secure it using straps with Velcro.
Assembling the undercarriage
Lay compact undercarriage on the ground, put on all wheels. Remove
protective covers of extensible locks on both ends of handle pipes. Stand
between the rear wheels of the stroller on the side of the handle. Brake the
undercarriage off by pressing the brake pipe to second marginal position,
hold your foot slightly on the wheel's axis, grab the handle and pull it
upwards, towards yourself, until you hear a click of the fuses. Make sure
that the undercarriage is secured by light pushing the handle downwards
(the undercarriage cannot be folded now).
Unfolding the undercarriage
Brake the undercarriage off by pressing the brake pipe to second marginal
position. With your foot on the pipe, grab left and right swivel assembling
controller on the handle pipe and rotate it inwards. To assembly the under-
carriage to the marginal position, press with your forearm on the handle
(until you feel a slight resistance from undercarriage chassis). Ensure with
transport safety-catch. Assembled undercarriage can be braked off with
your hand, if needed. Do not rest folded stroller by the extensible locks on
handle pipes, the folding function could be damaged.
Wheels
Mounting - press the quick fastening mechanism of the wheel, put the wheel
on the axis and release the mechanism. By pulling the wheel make sure, that
the wheel is mounted correctly and cannot get loose.
Releasing - press the quick fastening mechanism of the wheel and remove it
form the axis.
Parking brake
To apply the parking brake, press the plastic brake pedal. Please check the
brakes regularly and keep good functionality by cleaning and greasing of
the mechanism by silicone grease. ( plastic slider inside has to be loosely
movable)
Height of the handle
The height of the handle can be set by pressing the black plastic articula-
tions of the handle on both sides simultaneously and setting it to the desired
position.
Stroller operation:
Changing the position of the seat:
The seat can be positioned in or against the direction of travel. Apply the
breake on the stroller (stroller brake), take the child out off the seat. Grasp
the seat firmly, simultaneously press both buttons on the outside of the
adapter harness . Pulling upwards remove the seat from the chassis and turn
in/against the driving direction. Place onto the "clip- and -go" interface from
above , put on adapters on each side of the lock . Ensure proper placement
with signals of audible click. Pulling the seat up , make sure it is correctly
locked ( can not be ejected ) .
Positioning of the seat:
You can set four position of the backrest . When installing the backrest
unlock mechanism positioning the backrest upwards , adjust it to the desired
3
Werbung
