Connectivity - HEIDELBERG AMPERFIED Wallbox connect.home Betriebsanleitung

English
1
Fig. 8
Setting up the network connection
A. Connection set‑up via the app (WLAN / LAN)
1. Download the myAMPERFIED app.
2. Switch on the power supply and wait until the
c harging system is ready for operation (Status LED
of the charging system lights up blue). You have
20 m inutes to complete the next steps.
3. Now follow the instructions in the app and add
a device.
B. Connection set‑up via the Web interface (WLAN)
1. Switch on the power supply and perform the follow-
ing steps within 20 minutes.
2. Wait until the charging system is ready for operation
(Status LED of the charging system lights up blue,
Status LED of the communication module (Fig. 8)
lights up yellow, and Hotspot mode is active).
30
2 3
WARNING
10.124.8199/01

Connectivity

4 5
3. Briefly press the Connect button to activate WPS
mode (Status LED on the communication module
alternately illuminates yellow/green).
4. Then press the WPS button on your router.
5. The connection to the router has been established
as soon as the Status LED of the communication
module flashes green.
C. Connection set‑up via the Web interface (LAN)
1. Switch on the power supply.
2. Your network connection has been established
as soon as the Status LED of the communication
module flashes green.
Repeat the process if you cannot establish a connection
to the network. Additionally check the meanings of the
Status LED on the communication module in accord-
ance with the table below.
6 7
Status
Connect
Reset