Product Features - eisenblatter PTX COMPACT HT Originalbetriebsanleitung

5.5 Special safety instructions for mains powered
machines:
• Pull the plug out of the socket before making
any adjustments, changing tools, carrying out
maintenance or cleaning.
• Before connecting the mains plug, make sure that the
machine is switched off.
• Use of a fixed extractor system is recommended.
• Always install an RCD with a maximum trip current of
30 mA upstream. If the power tool is shut down via the
RCD, it must be checked and cleaned. See chapter 13.
Maintenance.
5.6 Reducing dust exposure:
Some of the dust created using this power tool
may contain chemicals known to cause cancer,
allergic reaction, respiratory disease, birth defects or
other reproductive harm. Some of these substances
include: lead (in paint containing lead), mineral dust
(from bricks, concrete etc.), additives used for wood
treatment (chromate, wood preservatives), some wood
types (such as oak or beech dust), metals, asbestos.
The risk from exposure to such substances will depend
on how long you or bystanders are being exposed.
Do not let particles enter the body.
Do the following to reduce exposure to these
substances:
• Ensure good ventilation of the workplace and wear
appropriate protective equipment, such as respirators
able to filter microscopically small particles.
• Observe the relevant guidelines for your material,
staff, application and place of application (e.g.
occupational health and safety regulations, disposal).
• Collect the generated particles at the source, avoid
deposits in the surrounding area.
• Use suitable accessories for special work (see
chapter 8.), thus less particles enter the environment
in an uncontrolled manner.
• Use a suitable extraction unit.
Reduce dust exposure with the following measures:
• Do not direct the escaping particles and the exhaust
air stream at yourself or nearby persons or on dust
deposits.
• Use an extraction unit and/or air purifiers.
• Ensure good ventilation of the workplace and keep
clean using a vacuum cleaner. Sweeping or blowing
stirs up dust.
• Vacuum or wash protective clothing. Do not blow, beat
or brush.
www.eisenblaetter.de
Original instructions PTX COMPACT HT

6. Product features

6.1. See page 2, figures A1 / A2 and
page 3, figure C:
A1-1 Handle
A1-2 Additional handle
A1-3 Particulate matter protection cap
A1-4 Spindle locking button
A2-1 Protective cover
A2-2 M14 thread holder
A2-3 Sliding on/off switch
A2-4 / C Speed adjusting wheel with electronics
signal indicator
EN
15