Troubleshooting; Possible Cause - Scheppach BSG500 Original Bedienungsanleitung

16. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event
of your machine failing to work properly. If you cannot localise and rectify the problem with
this, please contact your service workshop.

Possible cause

Over temperature
protection
Battery over-current
protection
Battery charging protection
Protection at low discharge
temperatures
Battery low voltage
protection
Power inverter overcurrent
protection
Power inverter overload
protection
Power inverter short-circuit
protection
Protection against
overvoltage while charging
Battery overheat protection
34 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Remedy
Check the ambient temperature, it must not be higher than
40 °C. Allow the product to cool.
Disconnect the charger from the product and restart it.
Contact the customer service department.
Check the ambient temperature, whether it is lower than
-20 °C.
Charge the device in time, restart it after it is fully charged.
Check if the AC output is overloaded or short-circuited.
Check if the AC output is overloaded.
Check if the AC output is overloaded or short-circuited.
Check whether the input voltage exceeds the maximum
input voltage.
Check the ambient temperature, whether it is higher than
40 °C. Leave the device to cool down.