Cleaning Of; The Upper Housing - Venta LW15 COMFORT PLUS Bedienungsanleitung

CLEANING OF

THE UPPER HOUSING

Caution! Ensure the appliance is switched off during all actions and the
!
switching power supply is disconnected from the power outlet!
01 Detach upper housing from lower housing. Press locking buttons so
that the ends stand up.
02 Fold side parts out of the way.
03 Fold ribbed wings out of the way.
04 Unplug the switching power supply from the drive unit
unit upwards and out
by releasing the bracket
opening of the upper housing
•
!
Do not disassemble the drive unit and the switching power
supply, immerse them in water or bring them into contact with
liquids!
•
Only clean the drive unit with fan blades and gear with a dry
cloth!
•
The disassembled upper housing can be cleaned under run-
ning water!
•
The disassembled upper housing must be absolutely dry be-
fore assembly!
05 Insert the drive unit into the upper housing from the correct side
the switching power supply from the bottom upwards and through the
opening of the upper housing
clicks into place
06 The outer ends of the locking buttons must be standing up. Fold the
ribbed side wings
. Close the upper housing correctly by pressing down on the outer ends
of the locking latches
. Disconnect the switching power supply cable
2
and pull downward and out through the
3
.
4
and plug it into the drive unit until it
2
. Affix the cable with the bracket
3
and upwards, then the side elements
1 2
and .
5 6
. Lift the drive
1
. Pull
1
.
4
nd
a
3 4
EN 29