Herunterladen Inhalt Inhalt Diese Seite drucken

Ferm LBM1008 Gebrauchsanweisung Seite 4

Inhaltsverzeichnis

Werbung

GB
Do not use power tools in the rain or wet
environments.
We strongly recommend the use of an RCD
(Residual Current Device) of not more than 30
mA, at the plug socket when using this
appliance.
Do not use power tools where there is a risk
of fire or explosion - i.e. near flammable
liquids or gases.
Do not allow people especially children or
pets into the area where you are working.
Do not let children or other people touch
power tools.
Store in a dry place well out of reach of
children.
Always use safety glasses. We also
recommend the use of ear protectors.
Wear the right clothes (long trousers) - not
loose fitting or jewellery and ensure garments
cannot come into contact with moving parts.
Wear non-slip shoes. Do not wear sandals or
open-toed shoes.
If you have long hair, tie it back safely to avoid
tangling it in moving parts.
Before using any power tool, check first for
damaged parts and if found do not use them
before the part or parts have been replaced
with new ones.
Do not use power tools when you are tired or
have been drinking alcohol.
Do not overreach while working - you may
lose your balance.
You must switch off your tool at the tool's
on/off switch after use.
Only use this appliance for its intended
purpose - blowing or sucking up leaves.
Do not point the blower at people or animals.
Do not blow debris in the direction of people
or animals.
Operate the appliance only in daylight or in a
good artificial light.
Do not place your hand inside the blower tube
or bag until the blower has been switched off
and the plug removed from the power supply.
Only use extension leads that are suitable for
outdoor use. The cord must be kept away
from excessive heat, oil, solvents and sharp
edges.
Do not use the vacuum to remove liquids of
any kind.
Do not vacuum up hot or burning materials
i.e. fire embers, matches, recently
extinguished cigarette stubs.
04
Never operate the vacuum without the bag
securely fitted.
Periodically check that all bolts and screws
are tight.
The operator or user is responsible for
accidents or hazards occurring to other
people or their property.
To prevent dust irritation we recommend the
wearing of a face mask.
Always direct the cable to the rear away from
the appliance.
Do not carry the appliance by the cable.
Disconnect the appliance from the mains
supply
• Before clearing a blockage.
• Before checking, cleaning or maintaining
the appliance.
• If the appliance starts to vibrate
abnormally.
• Whenever you leave the machine.
Always be sure of your footing on slopes.
Walk, never run.
Keep all cooling air inlets clear of debris or
obstructions.
Keep all nuts, bolts and screws tight to be
sure the appliance is in safe working
condition.
Check the debris collector frequently for
wear or deterioration.
Replace worn or damaged parts.
Use only genuine replacement parts and
accessories.
Immediately switch off the machine when:
Excessive sparking of the carbon brushes and
verticiliosis in the collector.
Interruption of the mains plug, mains lead or
mains lead damage.
Defect switch
Smoke or stench of scorched isolation
Electrical safety
When using electric machines always observe
the safety regulations applicable in your country
to reduce the risk of fire, electric shock and
personal injury. Read the following safety
instructions and also the enclosed safety
instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Ferm
Ferm
DK
45

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Flb-2500

Inhaltsverzeichnis