Inhaltsverzeichnis
Werbung
EN
A - Carrying handle
B - Sun canopy (built-in)
C - Push buttons for carrying handle
adjustment (L+R)
D - Belt hooks for lap part of belt (L+R)
E - Belt buckle with belt pad
F - Harness adjuster button
G - Storage compartment for user manual
H - Harness belt tensioner strap
I - Cover
J - Newborn inlay
K - Shoulder belts with removable
belt pads
L - Stroller release buttons (L+R)
M - Headrest
N - Belt hook for shoulder part of belt
O - Mounting bars for base
SAFETY
The car seat is developed for an intensive use of
approximately 6 years.
CabrioFix S i-Size car use
• When the car safety belt is used, make sure the car
safety belt buckle runs in a straight line and stays below
the belt hook of the car seat.
• The car safety belt must be threaded tight along all
green markings. For a proper installation, check the
instruction in this manual and the sticker on the side of
the car seat.
• Only use a forward-facing vehicle seat that is fitted
with a 3-point safety belt that complies with the ECE
R16 standard.
• The car seat can also be used with the Maxi-Cosi
FamilyFix 360 rotative base. The rotation feature of
the base helps you to get your child in and out of the
vehicle easily.
I
58
CabrioFix S i-Size 40cm-83cm / max. 13 kg
WARNING:
• Install the car seat only rearward facing in the car on a
forward facing vehicle seat.
• The car seat must always be locked in the rearward
facing position when travelling. Do NOT travel when the
car seat is rotated to a lateral (loading) position or to
any other unlocked intermediate position.
CabrioFix S i-Size and your baby
• Make sure you can fit no more than one finger
between the harness and your baby (1cm). If there is
more space than 1 cm, tighten the harness belt further.
• Make sure that the shoulder harness belts are at the
correct height. The shoulder harness belts should be on
or just below the baby's shoulders.
• Only use the newborn inlay of the CabrioFix S
i-Size until your baby exceeds the 60 cm length
limit. Afterwards remove the newborn inlay from the
CabrioFix S i-Size.
WARNING:
Never place the car seat on an elevated surface (such as
a table or chair).
Using CabrioFix S i-Size
• When CabrioFix S i-Size is installed on a stroller, always
make sure to use approved car seat adapters and to
secure CabrioFix S i-Size correctly.
CARE
• The cover, inlay, belt pads and sun canopy of the car
seat can be removed for washing. The front baleen of
the sun canopy needs to be removed before washing.
The harness webbing can be cleaned by using a wet
cloth.
I
Maxi-Cosi
Werbung
Inhaltsverzeichnis
