Toshiba dynadock U3.0 Benutzerhandbuch Seite 5

Only use TOSHIBA AC adaptor
Always use the TOSHIBA AC adaptor that was provided with your
■
product (that may have been provided with your product), or use AC
adaptors specified by TOSHIBA to avoid any risk of fire or other
damage to the product. Use of an incompatible AC adaptor could cause
fire or damage to the product possibly resulting in serious injury.
TOSHIBA assumes no liability for any damage caused by use of an
incompatible adaptor or charger.
Use correct power source
Never plug the AC adaptor into a power source that does not
■
correspond to both the voltage and the frequency specified on the
regulatory label of the unit. Failure to do so could result in a fire or
electric shock, possibly resulting in serious injury.
Do not handle the power plug with wet hands
Never attempt to connect or disconnect a power plug with wet hands.
■
Failure to follow this instruction could result in an electric shock,
possibly resulting in serious injury.
Choking hazards
Never leave small parts such as covers, caps and screws within the
■
reach of infants or small children. Swallowing a small part may cause
choking and suffocation resulting in death or serious injury. If a part is
swallowed, immediately take appropriate emergency action and consult
a doctor.
Avoid liquids, moisture and foreign objects
Never allow any liquids to spill into any part of your product, and never
■
expose the product to rain, water, seawater or moisture. Exposure to
liquid or moisture can cause electric shock or fire, resulting in damage
or serious injury. If any of these eventualities should accidentally occur,
immediately:
1. Turn off the product.
2. Disconnect the AC adaptor from the power plug socket and product.
Do not turn on the power again, until you have taken the product to an
authorized service center. Failure to follow these instructions could
result in serious injury or permanent damage to the product.
Never place your product or AC adaptor on a heat sensitive surface
Never place your product or AC adaptor on a wooden surface, furniture,
■
or any other surface that could be marred by exposure to heat since the
product base and AC adaptor's surface increase in temperature during
normal use.
Always place your product or AC adaptor on a flat and hard surface that
■
is resistant to heat damage.
User's Manual
dynadock™ U3.0
EN-5