Power Supply - Carson Startbox Betriebsanleitung

POWER SUPPLY

Stromversorgung:
2 x 7.2V NiMh
2 x 7.4 V LiPo
Connect the batteries with the two T-plug connectors.
speed controller (+) red
speed controller (-) black
Press the rear holder plate downwards. The motor (flywheel)
should now turn.
If the direction of rotation does not correspond to your vehicle,
you can reverse the polarity of the start box's motor.
To do this, open the 4 screws marked and remove the engine.
Then swap the motor cables.
Tip:
The flywheel should always be warmed up before the vehicle is
pressed onto it.
This "momentum" means the start box will not be as strained as
much.
For new engines or engines with high compression, the glow plug
should be removed and run through empty before starting for the
first time.
9 // GB