Carson Startbox Betriebsanleitung Seite 10

STARTING THE VEHICLE
• Place the start box on a flat, stable surface
• Place the vehicle securely using the centring pins
• Place glow plug connector on the engine
• Press the vehicle onto the start box
• Engine starts – remove the glow plug connector after a few
seconds
1
2
Push
TROUBLESHOOTING
Problem
Engine does not start Check glow plug connector
Do not continue using the start box
Engine flooded
unnecessarily
GB // 10
Remove the physical protection
to activate the start box - „Start-
box ON"
Integrate the physical protection
again start box is not used -
„Startbox OFF"
Tip:
The start box does not turn the engine – open the glow plug half
a turn.
After starting the engine, screw the glow plug firmly back in.
WARNING!
Risk of injury – activate rocker
switch only via the vehicle!
Solution
Check fuel supply to the motor
Unscrew the glow plug and let the engine run empty on the start
box
Remove excess fuel from the crankcase