Indicator Charge Level; Used Batteries; Operating The Chainsaw; Removing / Inserting The Battery - Grizzly AKS 2440 Lion Set Originalbetriebsanleitung

All manuals and user guides at all-guides.com

Indicator charge level

Press the „Press" button on the right of
charging level indicator (
to check the status of the battery.
The number of illuminated LED lights
shows the charge level of the battery. 4
lights means battery is fully charged. 1
light means that the battery needs to be
charged.

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery (
needs to be replaced. Only use an
OEM battery pack replacement avail-
able from our Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Cleaning and Main-
tenance").

Operating the chainsaw

Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled.
Make sure you have a secure
stance. Before starting, ensure that
the electric chainsaw is in contact
with no objects.
Caution! Saw can oil up, see notes
on Operation startup.
E 19b) in order
19) is used up and

Removing / inserting the battery

1. To remove the battery (19) from
F
the appliance, press the release
button (19a) on the battery and
pull out the battery.
2. To insert the battery (19), place
it on the guide track (17) and
push it back into the appliance.
It will audibly snap in.

Switching on

1. Check before the start, whether
G
sufficient chain oil is in the tank
and, if necessary, refill with
chain oil (see Chapter Opera-
tion Start).
2. Release the chain brake, where
you shift the brake arm (3) back
against the front grip (8).
3. Hold the chainsaw firmly with
both hands, with the right hand
on the rear grip (1) and the left
hand on the front handle (8).
Thumb and finger must close
securely over the handles.
4. For switching on, activate the
switch-on block (11) with the
right thumb and then press the
On/Off switch (10), the chainsaw
runs with highest speed. Re-
lease the switch-on block again.
5. The power saw switches off when
you release the On/Off switch
(10) again. Switching for continu-
ous running is not possible.

Checking the chain brake

The motor cannot be turned on if the
chain brake has engaged. Do not
employ the chain brake in order to
start the chainsaw or to switch it off.
GB
155