Cleaning And Maintenance - UNIPRODO UNI WS 5000PLUS Bedienungsanleitung

9. Follow steps 7-1 (in reverse order).
3.2. Automatic regeneration:
Automatic regeneration will start after approximately 10,000 l of water has been
filtered. The salt consumption is then 720g.

3.5. Cleaning and maintenance

a) Pull the mains plug before each cleaning, adjustment, replacement of
accessories and also when the unit is not in use.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
d) Do not spray the unit with a stream of water or immerse it in water.
e) Perform regular inspections of the unit checking technical fitness and any
damages.
f) Use a soft, damp cloth to clean the exterior of the unit.
g) Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the unit
is made.
h) Do not clean the unit with acidic substances, medical products, diluent, fuel,
oil or other chemicals as this may cause damage to the unit.
3.6. Troubleshooting
Problem
Control valve failure
Possible cause
1. The transformer is not
connected or is defective.
2. Failure of the power
outlet.
3. No power supply.
Action
1. Check the connection or
replace the transformer if
necessary.
2. If possible, repair the
outlet or replace it.
3. Connect to power supply.