General Instruction For 230V Machines; Specific Safety Instructions For Woodturning Lathes - Axminster AW240WL Originalanleitung

GENERAL INSTRUCTION FOR 230V MACHINES

The following will enable you to observe good working
practices, keep yourself and fellow workers safe and
maintain your tools and equipment in good working order.
WARNING!! KEEP TOOLS AND
EQUIPMENT OUT OF REACH OF
YOUNG CHILDREN
KEEP WORK AREA AS
UNCLUTTERED AS IS PRACTICAL.
UNDER NO CIRCUMSTANCES
SHOULD CHILDREN BE ALLOWED
IN WORK AREAS.
Mains Powered Tools
• Tools are supplied with an attached 13 Amp plug.
• Inspect the cable and plug to ensure that neither are
damaged. Repair if necessary by a suitably
qualified person.
• Do not use when or where it is liable to get wet.
Workplace
• Do not use 230V a.c. powered tools anywhere
within a site area that is flooded.
• Keep machine clean.

SPECIFIC SAFETY INSTRUCTIONS FOR WOODTURNING LATHES

1. Do not use 'split' work pieces.
2. Always start at the lowest speed when starting a new
task.
3. Try to render a new work piece "round" (or as close as is
practical) before turning.
4. Check that the tool rest is at or slightly below the centre
line of the work piece.
5. Check the work piece is securely mounted in the lathe
before switching on the power.
6. Rotate the work piece by hand, to check that it is:
centralised, clear of the tool rest, not 'split' or has loose
knots.
7. Where lathes have the facility to be reversed; check
the machine is rotating in the correct direction.
• Leave machine unplugged until work is about to
commence.
• Always disconnect by pulling on the plug body
and not the cable.
•
Carry out a final check e.g. check the cutting tool
is securely tightened in the machine and the
correct speed and function set.
•
Ensure you are comfortable before you start work,
balanced, not reaching etc.
• Wear appropriate safety clothing, goggles, gloves,
masks etc. Wear ear defenders at all times.
• If you have long hair wear a hair net or helmet to prevent
it being caught up in the rotating parts of the machine.
• Consideration should be given to the removal of rings and
wristwatches.
• Consideration should also be given to non-slip
footwear etc.
• If another person is to use the machine, ensure they are
suitably qualified to use it.
• Do not use the machine if you are tired or distracted
• Do not use this machine within the designated safety
areas of flammable liquid stores or in areas where there
may be volatile gases.
• Check cutters are correct type and size, are
undamaged and are kept clean and sharp, this will
maintain their operating performance and lessen the
loading on the machine.
• OBSERVE.... make sure you know what is
happening around you and USE YOUR COMMON SENSE.
8. If your lathe has the facility to run in reverse, you must
ensure that the mounting accessories (chucks, faceplates
etc.,) can be 'locked' onto the lathe mandrel, and in the case
of chucks have some form of security device to prevent
them 'unwinding' during reverse operation.
9. Make sure your tools are stored/racked away from the
turning area of the lathe. Do not reach over a rotating work
piece at any time.
10. Do not 'dig in' or try to take too large a cut.
11. Do not leave the lathe running unattended; or leave the
machine until everything is stopped.
12. If you are turning between centres with 'softish stuff' ,
check and reposition the tailstock centre frequently.
4