How To Insert Batteries - Uspa UB-6035R Bedienungsanleitung

Installation of remote control unit

How to insert batteries

1. Open the battery lid of the remote control and insert 3 AAA batteries into the battery compartment.
2. Check if the display appears properly.
3. Check if the remote control works properly while the seat is occupied.
4. Install the remote control bracket on the wall as shown below.
Note following precautions to prevent ruptured batteries and battery acid leakage.
- Use 3 AAA batteries only. Do not use rechargeable batteries.
- Do not use old and new batteries together. Use same type of batteries only.
- Make sure that all batteries are removed if the remote control is not used for a long time.
- LCD fades or blinks if the batteries are low. Change the batteries immediately.
- Settings (time, power saving mode) will be reset when batteries are replaced.
How to attach the remote control unit
Use double sided tape.
Recommended position of remote control
Use screw with plastic anchor.
Keep the remote control in the bracket
to prevent damage by dropping.
Magnetic
17