Remote Control - Uspa UB-6035R Bedienungsanleitung

Identification
•
This function is useful for public toilets when more than one unit of this product is installed.
• To prevent interference among units, main unit and remote control should be set with the same ID.
• If there is only one unit in the bathroom, you don't need to set ID.
• Initial ID of remote control and main unit is "0"
• There are 16 choices in ID (0~15).
How to set ID

Remote control

• Press "Stop" for 5 seconds and
• Press until your ID appears in display (00~15).
• Press "Stop" again to set ID, and display will return to stand-by mode.
Main unit
• After setting the ID of the remote control, plug in and press "Power/Bidet" on the left side of the main unit to
turn it off without sitting on the toilet seat.
• Press "Power/Bidet" for 1 second at least and simultaneously press "Stop" on the remote control. You will
hear a buzzer sound.
• The ID of the body will be preserved eternally after setting up, even in case of blackout or reactivating the
device after unplugging.
Warning
• If remote control and main unit IDs are different, bidet will not work. Make sure both sides are set with the
same ID. (Initially the respective ID of the remote control and the bidet are "0").
shows up in display.
11