Power Switch - Meec tools 019058 Bedienungsanleitung

actual material. The oscillation produces a
rougher surface, and therefore should be set to
0 for best surface fineness.
The oscillation is adjusted with the knob (6).
There are 4 fixed settings. Turn the knob slowly
until it clicks into place in the required setting.
0 – sheet metal, steel and rubber
1 – non-ferrous metal, hard wood, plastic
2 – wood
3 – wood (fast sawing)
FIG. 5
Saw line laser/LED work light
The saw line laser/LED work light is controlled
with the switch (7) on the front casing. The
laser projects a line in front of the product
to make it easier to control. Press the power
switch repeatedly to select the required setting
below.
FIG. 6
LED work light
On
Off
On
Off
WARNING!
Never point the laser beam at people or
animals. Never look directly at the laser
beam. The laser beam can cause permanent
eye damage.
Adjusting the speed of the saw
blade
The speed of the blade can be adjusted to suit
the actual material with the speed control (8).
The speed can also be adjusted when in use.
1 = low speed, 6 = high speed. After working at
Laser
Off
On
On
Off
low speed for some time the motor should be
run at maximum speed for about 3 minutes to
cool down.
FIG. 7

Power switch

Press and hold the power switch (9) to start the
product. Release the power switch to switch off
the product.
FIG. 8
Lock button
The product has a lock button (10) for the
power switch so that it does not need to be
kept pressed for long cuts.
• To lock the power switch (9) in the on
position, press the lock button (10) and
the power switch (9) at the same time.
Release the power switch first, and then
the lock button.
• To stop the product when the power
switch is locked, press and release the
power switch (9) once.
Using with a vacuum cleaner
1. Connect the vacuum cleaner to the dust
extractor adapter (13) on the product.
2. Move back the switch for sawdust (14).
FIG. 9
NOTE:
Move the switch forward if no vacuum
cleaner is connected, so that the flow of cold
air from the motor blows clean the saw line.
HOW TO USE
Preparations
• Measure out and mark the saw line before
sawing.
EN
33