Technical Data; Circular Saw Safety Warnings - AEG BKS18BL2 Übersetzung Der Originalanleitung

TECHNICAL DATA

Type
Production code
Battery voltage
No-load speed
Saw blade dia. x hole dia.
Saw blade thickness / tooth thickness
Blade teeth
Max. Cutting depth at 0° / 45° / 56°
Weight without battery pack
Weight according to EPTA-Procedure 01/2014 (Li-ion 2.0 Ah ... 9.0 Ah)
Recommended ambient operating temperature
Recommended battery types
Recommended charger
Noise Information
Measured values determined according to EN 62841. Typically, the A-weighted noise
levels of the tool are:
Sound pressure level / Uncertainty
Sound power level / Uncertainty
Wear ear protection!
Vibration Information
Vibration total values (triaxial vector sum) determined according to EN 62841.
Vibration emission value / Uncertainty
Cutting board
WARNING!
The declared vibration total values and the declared noise emission values given in this instruction manual have been measured in
accordance with a standardised test and may be used to compare one tool with another. They may be used for a preliminary assessment of
exposure.
accessories, keeping the hands warm (in case of vibration), and organising work patterns.
WARNING! Read all safety warnings, instructions,
Failure to follow all instructions listed below may result in electric
for future reference.

CIRCULAR SAW SAFETY WARNINGS

Cutting procedures
both hands are holding the saw, they cannot be cut by the blade.
you from the blade below the workpiece.
Less than a full tooth of the blade teeth should be visible below the
workpiece.
important to support the work properly to minimise body exposure,
blade binding, or loss of control.
Contact with a "live" wire will also make exposed
metal parts of the power tool "live" and could give the operator an
electric shock.
This improves the accuracy of cut and reduces the chance of blade
binding.
24
control.
blade washers and bolt were specially designed for your saw, for
optimum performance and safety of operation.
•
If
•
The guard cannot protect
• if the blade becomes twisted or misaligned in the cut, the teeth
It is
Kickback is the result of saw misuse and/or incorrect operating
procedures or conditions and can be avoided by taking proper
precautions as given below.
controlled by the operator, if proper precautions are taken.
ENGLISH
4757 88 01 XXXXXX MJJJJ
68 / 47.5 / 36 mm
L =90.5 dB (A) / K
pA
L =101.5 dB (A) / K
WA
a =2.2 m/s
h
saw blade, causing an uncontrolled saw to lift up and out of the
workpiece toward the operator;
down, the blade stalls and the motor reaction drives the unit
rapidly back toward the operator;
at the back edge of the blade can dig into the top surface of the
toward the operator.
BKS18BL2
Circular saw
18 V
0-5400 min
-1
190 x 30 mm
1.0 / 1.6 mm
24
4.0 kg
4.4 ... 5.2 kg
-18...+50 ºC
L18...
AL18G, BL1...
=3 dB(A)
pA
=3 dB(A)
WA
/ K=1.5 m/s
2 2
Blades that do not match the
The
Kickback