Advanced Options In A Source Mode - Baker Hughes Druck UPS-III-IS Bedienungsanleitung

7
Source mA with 24V*
Press mode key and select [Source mA and 24V]. The
calibrator supplies loop power of: 24 V [maximum],
(typically 21V) and 24 mA.
*Special condition for safe use, see page 3.

Advanced Options in a Source mode

Press the key and select mA Source or mA Source & 24V.
MODE
Use and
F2
Press the key (Advanced) and the display shows:
F1
Linear
Flow
Valve
Use and
F2
Advanced
Step
Auto-step
Span Check
Ramp
Note: Ramp function not available for valve selection.
Use to quit. The display returns to the selected source mode with the advanced setting
F1
available.
Advanced
Operation of Advanced Options
Press the key to switch the advanced setting on and off:
F2
e.g. on or off
Press or to:
step the output up or down.
step the span check maximum or minimum
start the "ramp".
Press then to start:
continuous auto-step.
or
continuous ramp cycle.
(Enter) to select the function.
simulates linear transmitters.
simulates flow transmitters.
simulates valve control signals.
(Enter) to select the Advanced option:
25% steps for linear and flow - fixed values for valve.
The same as step with a timed step interval.
Step between 4 (or 0) mA and 20 mA.
Automatic ramp between 4 (or 0) mA and 20 mA.
select
select
Enter
select
5
I/P
Adjust ±1 second
Adjust ±1 second
K0341 Revision B