Operating Modes; Measure Mode - Baker Hughes Druck UPS-III-IS Bedienungsanleitung

Operation
Keys
The key switches the loop calibrator on and off. Press and hold for 2
seconds.
The key changes the measure or source operating mode. Pressing
MODE
the keys makes menu selections, sets numerical values and
controls step and ramp functions (up/down).
The select advanced functions shown on the bottom of the
F1 F2
display. When no key is pressed for 10 minutes, the loop calibrator times
out and switches off. To disable this automatic time out, select autpower
down in the set-up menu.

Operating Modes

Pressing switches the instrument on and the display shows the start-up sequence. Pressing
, at this time, the display shows the information screen:
F1
Pressing , at this time, the display shows the set-up screen:
F2
The calibrator can be used in two modes measure or source.

Measure mode

The display shows the measured value; depending on the settings made in set-up and advanced
settings:
When measuring current pressing
of 4 to 20 mA or 0 to 20 mA).
When measuring voltage pressing
To measure continuity the displays shows an open or closed switch symbol with an audible signal
on switch closure.
Information
F1
Serial number
VERSION
CAL. DATE
HART
BATTERY
enables linear or flow, pressing
F1
changes the resolution between 0.00V and 0.000V.
F2
3
F1
SPAN CHECK
adjust
adjust
4-20mA/0-20mA
mA/%
ON/OFF
ON/OFF
menu
menu
enables mA or % (value
F2
K0341 Revision B
F2
MODE