Klarstein SKYTOWER 360 SMART Bedienungsanleitung Seite 31

When turning on the up-down swing function after it is first powered on, the motor will
find the original point first .The horizontal blades may be closed for about 10 seconds
and then swing upwards to open. This is a normal phenomenon.
When the up-down swing button
horizontal position and stop.
Setting the speed
The speed button can be used to adjust the wind speed. Pressing the speed button
several times cycles through the speed levels in the following order:
Low > Medium > High > Low.
The speed levels are displayed in numbers on the screen:
Speed Display
Low 1
Medium 2
High 3
Dry wind function
If you press and hold the speed button
started. The appliance is running at high wind speed and the screen shows "3" and the
indicator flashes for 20 minutes.
While using this function, all buttons except the ON/OFF button are inactive. Press and
hold the speed button
When the dry wind function has been activated for 20 minutes, the appliance
automatically switches off and goes into standby mode.
Setting the timer
The timer button can be used to set the time until the appliance switches off
automatically. You can set a time between 0-9 hours. The time until automatic switch-off
can be adjusted in hourly steps and is displayed on the screen. When the appliance is
switched on, press the timer button
flash on the screen. You can now set the desired time until automatic switch-off. Then
press any button (except the ON/OFF button) or wait 5 seconds to exit the setting.
After the timer has been activated, the remaining time until switch-off and the currently
set speed are displayed alternately on the screen at intervals of 10 seconds. The
corresponding indicator light (1 1/6) lights up in each case. As soon as the time has
elapsed, the appliance switches off automatically and goes into standby mode.
is off, the horizontal blade will swing to the
for 3 seconds, the dry wind function is
for 3 seconds to cancel the function.
. The timer indicator (1 1) and the time indicator
EN
31