Warranty Terms - Bestway FLOWCLEAR 58391 Gebrauchsanweisung

• This product is not intended for commercial use.
RCD WARNING
• Risk of electric shock. The RCD plug must be tested before each use.
• Do not use the pump if this test fails. For assistance, please visit the support
section on our website, www.bestwaycorp.com.
• Insert the RCD plug into a residual current device (RCD) having a rated
residual operating current not exceeding 30mA.
• Before inserting plug into a power outlet, make sure the current rate of the
power outlet is suitable for the pump.
SAVE THESE INSTRUCTIONS
ATTACHING A BASE
EN60335-2-41 TEST standard requires the filter pump to be vertically
fixed on the ground or a base made of wood or concrete before use.
There should be two holes 7mm in diameter on the base, the space
between which should be 256mm. Put filter pump on the base and attach
them together by fastening the bolts and nuts. All the base parts should
weigh at least over 18kg to prevent the pump from accidentally falling.
SETUP
CHECK LIST
To check the parts included in the box, consult the part list inside this manual. Verify that the equipment components
represent the model that you had intended to purchase. In case of any damaged or missing parts at the time of purchase,
visit our website bestwaycorp.com/support.
CHOOSE THE CORRECT LOCATION
Place the Filter Pump on a solid and level ground; it must be positioned on the same level as the base of the pool. If the
Filter Pump is in an upper or lower position than the base of the pool, the performance and life span of the Filter Pump can
be compromised. The pool and the Filter Pump have to be positioned in an area with adequate drainage and easy access
for maintenance operations. Never place the Filter Pump in a area that may accumulate water.
INSTALLATION
• For the installation instructions, refer to the illustration steps
only. May not reflect actual product. Not to scale.
• Bestway will not be responsible for any damage caused to the Filter Pump due to mishandling or failure to follow these
instructions.
• It is imperative to check that the hydraulic connectors are not obstructed.
• Do not dry run the Filter Pump. Make sure both the pool's inlet and outlet valves are fully covered by water before
operating the Filter Pump.
MAINTENANCE
Make sure that the Filter Pump is unplugged before any maintenance.
•
• For the maintenance instructions, refer to illustration steps
May not reflect actual product. Not to scale.
• To optimize the Filter Pump performance and for sanitary reasons, we suggest replacing the filter cartridge with a new
one every two weeks.
STORAGE
• Remove all accessories; be sure that Filter Pump, hoses and debris screens are completely clean and dry before the
storage. If all the parts are not completely dry, mold may result.
• Before storage, remove and dispose of the filter cartridge.
• We strongly recommend disassembling the Filter Pump when the environment temperature is below 10ºC / 50ºF.
• Store the Filter Pump in a dry place with a moderate temperature between 10ºC / 50ºF and 38ºC / 100ºF.

WARRANTY TERMS

For information concerning warranty terms, visit our website at: www.bestwaycorp.com.
inside the manual. Drawings are for illustration purposes
inside the manual. Drawings are for illustration purposes only.
5
2-M6 nut
2-M6 bolt