Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

The camera recording angle and motion detection angle is affected by the placement of the device.
Check that the device is within range of your network access point.
You may need to set up a wireless repeater to improve the connection.
Make sure there is a suitable power outlet near the mounting location to connect the power adaptor.
8.2 Antenna
For best reception, the antenna should point towards the sky.
8.3 Mounting
P
:
RECONDITIONS
a
Check that the provided screws are appropriate for the surface material. If in doubt consult a profes-
sional.
1. Use the mounting holes on the back of the product as a template to mark where to drill.
2. Attach the product using the supplied dowels and screws.
à
Make sure the product is securely mounted before letting go.
9 Install/replace microSD card
Important:
The microSD card should be formatted using FAT32 or exFAT file systems. Refer to your
computer software instructions for information about how to do this.
Insert the microSD card into slot, it will "click" into place.
Remove using the tip of your finger to press down until it "clicks", then release to eject.
10 Operation
10.1 Power ON
The product will switch ON when connected to the power supply.
It will take a few moments for the product to load up.
An audio prompt will indicate the product has fully started up.
10.2 Reset the camera
Perform a reset if the camera is not functioning correctly or you would like to put the camera into pairing
mode.
If the product has already been paired with the app, you will need to "Remove Device" via the app before
you can pair it again.
1. Press and hold the reset button until you hear a tone.
à
Wait a few moments for the system to restart.
2. Repeat the pairing procedure.
10.3 Low light recording
The device is equipped with a light sensor that automatically triggers "night vision" when ambient light falls
below a certain level. The recorded image will be in black and white.
10.4 Motion tracking
The product is equipped with motion tracking that will track a human-like figure when movement is detec-
ted.
10.5 Motion detection
The product is equipped with motion detection that will track an object when movement is detected
within the detection area.
Sensitivity to motion can be controlled via the app.
11 Application "Smart Life - Smart Living"
11.1 Download application
TM
Compatible Android
and iOS apps are available from their respective app stores.
Search for "Smart Life - Smart Living".
11.2 Pairing
Important:
– The product is compatible with 2.4 GHz networks.
– Enter the exact network name (case sensitive).
– Connect the mobile device to the same Wi-Fi network the product will connect to.
– If you are giving the product to a third party you did not "Share Device" with, you may need
to "Remove Device" through the application before they can link it to their account.
Connection pathway: All Devices → Add Device → Add Manually → Security & Video Surveillance
→ Smart Camera (Wi-Fi).
Available pairing methods are as follows:
Connection method
QR code
AP mode
EZ mode
LAN cable
11.3 Remove device
Open the app and navigate to the product icon under the "All devices" tab.
Press and hold the icon then select "Remove Device".
12 Cleaning and care
Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions. They damage
the housing and can cause the product to malfunction.
– Do not immerse the product in water.
1. Disconnect the product from the power supply.
2. Clean the product with a dry, fibre-free cloth.
5
Available
Yes
No
No
Yes
13 Disposal
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product in accordance with applicable regulatory
guidelines.
You thus fulfill your statutory obligations and contribute to the protection of the environment.
14 Declaration of Conformity (DOC)
Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau hereby declares that this product con-
forms to the 2014/53/EU directive.
Click on the following link to read the full text of the EU declaration of conformity:
downloads
Enter the product item number in the search box. You can then download the EU declaration of conform-
ity in the available languages.

15 Technical data

15.1 General
Input voltage/current.............................. 12 V/DC, 1 A max.
Power consumption............................... max. 12 W
Audio ..................................................... 2-way
Resolution.............................................. HD 1920 x 1080 p
IR LED range......................................... max. 20 m
Frames per second................................ 15 fps
Recording (motion activated)................. Continuous loop
File record size ...................................... 15s (motion detection mode)
Video compression................................ H.264
Video format .......................................... MP4
Pan/tilt.................................................... 355° pan, 90° tilt
Storage.................................................. MicroSD class 10 (max 128 GB)
MicroSD file system............................... FAT32
Ingress protection.................................. IP65
Operating/storage conditions................. -20 to +40 °C
Dimensions (L x W x H)......................... 240 x 93 x 130 mm (with antenna)
Weight ................................................... 360 g (with antenna)
15.2 Motion detection
Detection angle...................................... 86° horizontal, 46° vertical
Detection range ..................................... 8 m
15.3 Wireless connectivity
Bandwidth.............................................. Min. 2 Mbps upload speed
WLAN .................................................... IEEE 802.11 b/g/n, 2.4 GHz
Frequency range ................................... 2.412 - 2.462 GHz
Transmission distance........................... 20 m
Transmission power .............................. 3 dBm
15.4 LAN
Port........................................................ RJ45
Cable ..................................................... Max. 100 m
15.5 Adaptor
Input....................................................... 100 - 240 V/AC, 50/60 Hz, 0.6 A
Output.................................................... 12 V/DC, 2 A
15.6 Application
Supported OS........................................ Android 5 (or higher), iOS 11 (or higher)
Application name................................... Smart Life – Smart Living
Application settings and features........... IR night vision settings, 2-way talk, Motion detection and
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication reflects the technical status at the time of printing.
Copyright by Conrad Electronic SE.
*2380480_V2_0921_dh_mh_en I2/O2
www.conrad.com/
2 megapixels
Until SD card full (manual recording)
tracking settings, siren light control, timer, Amazon Echo,
Google Home, firmware upgrade, flip screen, HD/SD resolu-
tion setting

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

2380480

Inhaltsverzeichnis