Operation; Using The Solar Shower; Cleaning; Disassembly - Steinbach Pool Professional The Gate Originalbetriebsanleitung

2. Slide the connecting element between the
additional tank and the shower head upward.
Unscrew the vent valve
tank so that air can escape from the tank.
6
3. Turn on the water supply faucet. Turn the
faucet all the way to the "hot" position and
4
open it. In this position, the tank fills fastest.
Water flows into the tank. It takes approx. 5
minutes for the tanks to fill.
4. As soon as water runs steadily out of the
connection for the vent valve, screw the vent
valve into the addition tank.
5. As soon as water runs uniformly out of the
shower head
1
6. Turn off the faucet of the water pipe.
The tank is filled.

Operation

Using the solar shower

Observe the following before using your solar shower:
- Bacteria can multiply in warm water if the product is not used for longer periods. Risk of infection!
The tank must be drained.
- The water temperature in the tank depends on the level of sunshine. In cloudy weather, the water
will take longer to heat up. The water can become very hot in the case of intense sunlight.
- Remove obstacles from the showering area.
To use your filled solar shower, proceed as follows:
1. Connect a garden hose to the hose adapter
garden hose so that no one can trip over it. Turn on the water supply faucet.
2. Turn the faucet
3. Turn the faucet left or right to set your desired water temperature. Use the faucet to control the
water temperature and quantity, and enjoy showering in warm water.
4. After showering, close the shower faucet. Turn off the faucet of the water pipe.
The shower is finished.
Water is still coming out of the shower head even after the faucet has been closed. This
is caused by the water heating up in the unpressurized tank and is not a defect!

Cleaning

Only clean the product with a standard bathroom cleaner, clear tap water and a lint-free cloth.
Aggressive cleaning agents can damage the product. Dry the product with a lint-free cloth.

Disassembly

Draining the tank

Disconnect the solar shower from the water pipe. Open the faucet and unscrew the drain cap to drain
the water from the tank.
Unscrew the vent valve

Dismantling the product

To dismantle the solar shower, proceed as follows.
1. Slide the connecting elements
18
from the additional
2
, close the faucet.
to the center position (between hot and cold). Open the shower faucet.
4
from the additional tank
2
between the tanks
3
8
2
6
and the faucet of the water pipe. Position the
15
(see section "Filling the tank").
6
and the shower head
5 6
upward.
1