Installation; Assembling The Solar Shower; Setting Up The Solar Shower; Filling The Tank - Steinbach Deluxe Originalbetriebsanleitung

Installation

Assembling the solar shower

To assemble the solar shower, proceed as follows:
2
10
1
2
3
1. Put the sealing ring
2. With an Allen wrench
tank .
3
3. Screw the hose adapter
4. Place the O-ring on the drain cap
The solar shower is assembled.

Setting up the solar shower

Position the solar shower at the prepared setup location. Make sure that the solar shower is pointing in
the correct direction.
The second person supports the shower while you screw the base of the shower into the floor with the
correct attachment materials.

Filling the tank

To fill the tank of your solar shower, proceed as follows:
3
1. Connect a garden hose to the hose adapter
garden hose so that no one can trip over it.
2. Turn on the water supply faucet. Turn the faucet
this position, the tank fills fastest. Water flows into the tank. It takes approx. 3 minutes for the tank
to fill.
3. As soon as water runs consistently out of the shower head
4. Turn off the faucet of the water pipe.
The tank is filled.

Operation

Using the solar shower

Observe the following before using your solar shower:
- Bacteria can multiply in warm water if the product is not used for longer periods. Risk of infection!
The tank must be drained.
- The water temperature in the tank depends on the level of sunshine. In cloudy weather, the water
will take longer to heat up. The water can become very hot in the case of intense sunlight.
- Remove obstacles from the showering area.
3
9
into the opening in the top of the tank
2
and the attachment screws
9
onto the hose connection.
4
and screw the drain cap into the tank.
5
4
.
3
, screw the shower head
10
and the faucet of the water pipe. Position the
all the way to the "hot" position and open it. In
8
, close the shower faucet.
1
4
5
onto the
1
17