Start-Up And Operation - Hama FC-10C Flex Bedienungsanleitung

4. Start-up and operation

Note
• To be able to charge your device via the wireless charger, it must be compatible with induction charging
technology. Please refer to the operating instructions of your device for more information.
• Note that mobile phone cases, covers, etc., and other materials between the wireless charger and the
back of your device may interfere with or even prevent the charging process.
Note – 12 V, 24 V vehicle electrical systems
The charger is suitable for 12 V and 24 V vehicle electrical systems.
• Fasten the wireless car charger over the enclosed grating holder (4) to your vehicle's grating.
• Connect the enclosed USB-A to USB-C connector cable to the USB-C input (1) on the inductive charger
and the enclosed car adapter for the power supply (5).
• When the power supply is active, the status LED (2) lights up red.
• Use the adjustment lever (3) to set the holding jaws to the size of your smartphone. You can move the
controller slightly by pressing it to release the locking mechanism.
• First place the holding jaws in the maximum opening position for setting them to the size of your
smartphone.
• Then place the smartphone in the charger and, using the adjustment lever, slide the holding jaws together
until the smartphone sits rmly in the holder.
• Release the lever to lock the position.
• Thanks to the exible holding arms, you can now easily x your smartphone in the charger and remove it
again at any time. The holding arms always remain in the position you set them in earlier.
Warning
• Only use suitable charging devices or USB ports to charge the product.
• Do not use defective chargers or USB ports and do not attempt to repair them.
• Now place your device with its rear on the wireless charger (B).
• The charging process begins as soon as an effective induction eld has been established. The status LED
(2) starts to ash red. The current charge status is displayed on your device.
• If no induction connection can be established, change the position of your device if necessary (B).
• The charging process ends automatically once your device's battery is fully charged. The status LED (2)
lights up solid green.
• Remove your device from the wireless charger and disconnect the wireless charger from the power supply.
• If metallic or magnetic objects are on the charger, this is indicated by status LED (2) ashing green and
red alternately. After ashing ve times, the status LED (2) goes out.
Note - car battery
With some vehicles, it can happen that power continues to be supplied even though the ignition has been
switched off. You should therefore disconnect the product from the line connection when not in use to
protect your car battery from being drained.
8