salvus Torino Bedienungsanleitung Seite 14

Attention!
• Open the safe door within six seconds otherwise the lock will lock automatically. In that case you
can open the lock again by entering the code.
• If you press the "*" key and you hear three beeps and the red LED flashes twice the lock has an
error. In most cases this is caused by empty batteries. Install new batteries to be able to open the
door. If the problem persists, please contact our service department.
• After entering a wrong code, you will hear a beep three times and the red LED flashes. Wait until
you hear a beep and the green LED flashing before trying to open the safe again.
• After entering a wrong code three times, the keyboard will lock for 5 minutes while the red LED
keeps flashing. Wait until you hear a beep and the green LED flashing before trying to open the
safe again.
VII. Replacing batteries
When the batteries are almost empty, you will hear 5 beeps and the red LED will light up when
you press the "*" key.
The battery compartment is located below the keyboard (see figure 2).
The safe requires four 1.5V AAA batteries.
Please respect the environment and make sure the batteries are disposed of correctly.
GENERAL
SIGNAL
1 x "beep" +

2 x "beep" +

WHEN OPENING THE LOCK
SIGNAL
3 x "beep" +

3 x "beep" +

during 5 minutes

5 x "beep" +

DURING PROGRAMMING
SIGNAL
1 x "beep" +

2 x "beep" +

3 x "beep" +

1 x "beep" +

14
EXPLANATION OF SOUND AND LIGHT SIGNALS
EXPLANATION
Confirmation of keystroke (except «ENTER»)
Confirmation of keystroke «ENTER»
EXPLANATION
Wrong code
cannot be opened
3 x wrong code
Batteries almost empty
EXPLANATION
Wrong entry
Programming confirmed
Programming error
No entry for 10 seconds
Programming cancelled
SOLUTION
re-enter the code again after
1 x "beep"+

Replace batteries
re-enter the code again after
1 x "beep"+

Replace batteries
SOLUTION
Repeat procedure after
1 x "beep"+

Repeat procedure after
1 x "beep"+

Repeat procedure