4. GETTING STARTED
4.1 Main Unit:
•
Open main unit battery compartment cover.
•
Insert 3 x AA batteries observing polarity ["+" and" –" marks].
•
Replace main unit battery compartment cover.
•
Use a pin to press the RESET [B6] button on the rear of the main unit, the main unit is now
ready for use.
4.2 Outdoor Thermo Sensor
•
Batteries compartment (D3) of thermo sensor is locating behind the back cover,
•
Insert 2 x AAA batteries observing polarity [ "+" and "–" marks]
5. INSTALLATION
5.1 Main Unit
•
Wall mounted by the hanging hole, or place the unit onto flat surface.
5.2 Outdoor Thermo sensor
The remote sensor should be securely mounted onto a horizontal surface.
Note: Transmissions between receiver and transmitter can reach up to 30m in open area.
Open Area: there are no interfering obstacles such as buildings, trees, vehicles, high
voltage lines, etc.
6. WEATHER FORECAST FUNCTION
6.1 Operation
•
After Batteries inserted, weather icon flash (A4) on the LCD. Enter the current weather
pressing "+" (B5) or "- "(B7) button. Press "MODE" (B3) button to confirm the setting.
The weather forecast may not be accurate if the current weather entered is not correct.
•
The current weather status should be entered again if the altitude of the main unit is
changed. (Barometric pressure is lower at higher altitude location. Therefore, altitude
change will affect the weather forecast). The weather station will start the first forecast
at 6 hours later after the current weather status is entered.
6.2 Weather Conditions
There are totally 5 different weather status animations in the weather forecast.
Sunny
SlightlyCloudy
Cloudy
Rain
ENG - 25
ENG
Freezing or
Snow