Safety Instructions; Technical Data; Physical Characteristics - Bartec 07-7331-2307/0000 Betriebsanleitung

Operation Instruction (Translation)

3. Safety Instructions

Designated use
The control and regulating components may only be operated in a
clean, undamaged condition and is admitted only for a proper and
designated use. With
manufacturer`s responsibility goes out.
The correct laws, norms and directives for use or project engineering
must be kept.
The assembly/dismantling of the regulating and control components
must be conducted by qualified personnel authorised and trained to
install electrical components in potentially explosive areas. The user
manual should be read and have been understood. The
responsibility for the assembly/dismantling, installation, service and
the operation lies carries the operator.
Danger, Warning and Note Symbols
Safety instructions and warnings are specially highlighted in these
operating instructions and marked by symbols.
DANGER
The DANGER sign draws attention to a direct threat which if not
avoided will lead to death or very serious injuries.
WARNING
WARNING draws attention to a possible threat which if not avoided
can lead to death or very serious injuries.
CAUTION
CAUTION draws attention to a possible danger which if not avoided
can lead to slight or minor injuries.
ATTENTION
ATTENTION draws attention to a potentially damaging situation
which if not avoided can cause damage to the equipment or to
objects in its vicinity
Important instructions and information on effective,
economical & environmentally compatible handling.
Max-Eyth-Straße 16
DE
97980 Bad Mergentheim
GmbH
Deutschland
MODEX
PROFIBUS-Interface 4 x RTD in Ex
infringement any guarantee
Tel.: +49 7931 597-0
Fax: +49 7931 597-119
Regulating and control components
i

4. Technical Data

Physical characteristics

Construction
and
Enclosure material
Protection class
(EN/IEC 60529)
Electronic module
Terminals
Terminals with cover
Electric connections
Attachment onto mounting
rail (EN/IEC 60715)
Terminal marking
Terminal screws
Terminal screw torque
Mounting position
Weight
Dimensions
(width x height x depth)
info@bartec.de Vorbehalt
www.bartec.de
Typ 07-7331-2307/0000
flameproof clip-on enclosure
for TH 35 rail
reinforced thermoplastics
IP 66
IP 20
IP 30
terminals 2.5 mm
2
fine-stranded
TH 35 x 15 (7.5)
inscription label
M 2.5 x 0.45 mm
0.4 Nm
Any
2.1 kg
170 mm x 102 mm x 96 mm
Technische Änderungen behalten wir uns vor.
Änderungen, Irrtümer und Druckfehler begründen
keinen Anspruch auf Schadensersatz.
,
3/18