Star Progetti VARMATEC RADIO 550/20NR Gebrauchsanleitung Seite 17

OPERATION OF THE REMOTE CONTROL
3
Enable PIR* from remote control
Take the supplied radio control unit cod. PTVTEL
By using the "+" and "-" buttons select channel 14 Fig.15 and immediately after press
•
the button as shown in Fig. 16
The blue LED on the heater starts flashing twice to confirm the operation Fig.17
•
4
Disable PIR* from remote control
Take the supplied radio control unit cod. PTVTEL
When switched on for the first time with the power supply switched on (230Vac),
•
pressing the ON button will set the controller to idle (red LED).
During the following starts, pressing the ON button will set the controller to the last
•
power selection set (status MEMORY).
Fig.15
•
NOT INCLUDED
ACCESSORY
COD.ST15
Fig.16
17
2x
Fig.18
Fig.17
CHANNEL 14
3x