AVENLI RF-21-CZ2 Benutzerhandbuch Seite 12

STEP 3. INSTALLATION OF THE HORIZONTAL SUPPORT
TYPE A
TYPE B
STEP 4. INSTALLATION OF THE T-JOINT (FOR TYPE A)
belt
STEP 5. INSTALLATION OF THE T-JOINT (FOR TYPE B)
belt
1. Connect the connecting end of the T-joint
to the downstream horizontal pipes.
2. Insert the pin firmly into the hole of the
connected horizontal pipe and T-joint.
3. Place the cap on the upright.
4. Insert the vertical rack into the T-joint
through the belt.
5. Insert the pin into the hole of the T-
joint and the vertical upright.
TIP: If you can't find the hole on a horizontal
pipe or vertical standpipe, rotate the pipes until
the pin meets the hole.
1) Connect the connecting end of the T-joint
to the downstream horizontal pipes.
2) Insert the pin firmly into the hole of the
connected horizontal pipe and T-joint.
3) Place the cap on the upright.
4) Insert the vertical rack into the T-joint
through the belt.
TIP: If you can't find the hole on a horizontal
pipe or vertical standpipe, rotate the pipes until
the pin meets the hole.
12