Western Co WRD Benutzerhandbuch Seite 48

List displayed:
˄
˄
|
Ubat GE Start:
|
|
|
Ubat GE Hist: +8 V
|
|
|
|
|
|
AUTOTEST: -->
|
|
RESET: RUN
|
|
UPDATE FW: ---
List displayed:
W-INVERTER SETUP:
not present
List displayed:
WRD SETUP:
Oper.Mode: MONITOR
Backlight: auto OFF
|
|
RESET: RUN
UPDATE FW: RUN
|
|
|
|
|
Tech. Menu Psw:
User manual
Value: Settable values and description:
<---..62 V>: In Monitor mode, it defines the voltage threshold
---
<+8..+11 V>: In Monitor mode, it defines the hysteresis voltage
-->: Goes to the W-INVERTER AUTOTEST (CEI 0-21) menu.
RUN : Resets the W-INVERTER.
RUN : *CAUTION* starts the procedure to update the firmware in
Value: Settable values and description:
Device not present.
Value: Settable values and description:
MONITOR; CONTROLLER: Operatimg Mode: Monitor o Controller.
auto OFF; always ON: LCD backlight, Auto-OFF or always ON.
RUN : Resets the WRD device.
RUN : *CAUTION* starts the procedure to update the firmware in
00
<0..FF>: password to access the Technical Menu.
WRD
below which the contact for switching on the GE is
closed.
to be added to GE start, to obtain the voltage threshold
above which the contact for switching on the GE is
reopened.
(see §5.5 of the Leonardo PRO X manual Italian version)
the WBM device. The firmware update
in the uSD card.
the WBM device. The firmware update
in the uSD card.
To start the procedure press both keys ↑ and ↓.
*CAUTION* Technical Menu is reserved for factory checks.
20
EN
MENU 8.3
file must be present
MENU 8.3
MENU 8.4
file must be present