Basic / Advanced; System Setup; Date Time Setup; Data Logger Setup - Western Co WRD Benutzerhandbuch

Inhaltsverzeichnis

Verfügbare Sprachen

WRD

User manual

- Counters Reset: in one of the submenus 5.x keep pressed for 1 sec. the EDIT key so as to select the counter start

date. Press the UP key, the word "RESET" will appear. Then press and hold for 1 sec. the OK button.

- Start Autoconfig: in menu 8.0 keep pressed for 1 sec. the EDIT key to enter editing mode, then the SELECT key

and modify the first item with INC to display "RUN". Press the UP button, "SCANNING..x / 32" will appear. At the

end of the procedure to save press and hold for 1 sec. the SAVE key.

3.2. Basic / Advanced

Through the display it is possible to view a series of information regarding the operation of the system and, if

necessary, make changes to the various settings. Normally the parameter "U.I. Mode" of menu 7.4 INFO is set to

the value "Basic", in this mode you can only access the SETUP menus 7.3 and 7.4 and only perform the internet

connection settings. Setting to "Advanced" allows you to access all menus.

(N.B. This setting is recommended only to qualified personnel, during the installation and system setting phase)

In the menu: 7.0 SYSTEM the system settings are executed, the list of parameters changes according to the

current configuration. Detailed explanations are described in the chapter Configurations.

In the menu: 7.1 DATE / TIME you set the system clock and the time zone (Timezone). It is important to correctly

set this last parameter with the Timezone of the place where the system is located, so that the remote clock can

be updated correctly.

In the menu: 7.2 DATA LOGGER you can enable the data logger by setting the minutes for the sampling

parameters: 10min. is the default value (enabled). It is also possible to request information regarding the μSD.

In the menu: 7.3 NETWORK you make the settings of the various network parameters. The DHCP function is set

by default, which automatically retrieves the necessary values. The connection to the remote server can be

enabled or disabled by the user. The internet connection is essential to receive updates and remote assistance.

Inhaltsverzeichnis