Storage And Transport; Malfunctions And Troubleshooting; Preparing For Disposal - Lux Tools A-EWSU-C Set Originalbetriebsanleitung

GB

Storage and transport

If there is danger of frost, dismantle the device and
accessories, clean and store them in a place pro-
tected from frost.
NOTICE! Danger of damage to the
device! Frost will damage the device and
accessories, since they always contain
water!
Storing
– Store the device and any accessories in a dry,
well-ventilated place.
– In case of longer periods without operation, pro-
tect the device and its accessories against soiling
and corrosion.
Fault/malfunction
Manual function
Timing error
Product not working
Dripper can't effluent
Water ingress
Can't charge
Low flow
Low voltage
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
20
Transport
– Use the original packaging to ship whenever pos-
sible.

Malfunctions and troubleshooting

In the event of a malfunction...
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Remedy
[ON]: In the [ON] position, the pump can remain activated and the wa-
ter flow is normal
[OFF]: In the [OFF] position, the pump remain closed and the water
flow is closed
The pump shuts down within ±5 minutes of the running (watering) time
setting
programs interval time should greater than running time
When you use it for the first time, you need to press and hold the man-
ual button for more than 5 seconds. After the indicator light flashes, it
means that the whole machine has started to enter the working mode
Check the product working conditions and whether it shows low voltage
(when the battery voltage is low, the pump is turned off, and the low
voltage indicator flashes continuously)
setting conforms to the program setting (interval time is greater than
running time)
Pump suction height ≤2 m; pump head height ≤2 m
Install the water inlet and outlet related parts
Adjust the tightness of the dripper
Check that the water inlet pipe is submerged in the water level
Clean the dripper
Install firmly to prevent the product from falling into the water, use in
IPX4 waterproof standard environment
USB charging port seal needs to be tightly closed
Water bottle installation thread matches and tightens
USB charging cable and the power socket must matching
power socket specification: 2000 mAh
Pump suction height ≤2 m (the lowest suction water level to the vertical
height of the pump); pump lift height ≤2 m (the height difference from
the pump to the final water outlet)
Adjust the tightness of the dripper
Clean the dripper
Charging: Charge via USB port under 5 V voltage, the charging indica-
tor will be on, and the indicator will be off when fully charged.

Preparing for disposal

Removing the battery
DANGER! Danger of physical injury and
death! Improperly conducted repairs may
prevent your appliance from working safely.
Such repairs will endanger you and your sur-
roundings.
Note: The battery is not replaceable.