Rosenbauer RTE PS 2 Power Station Betriebsanleitung Seite 68

Operation
Operation
Charge battery with public supply
Charge battery with PV-panels
68 / 78
Charging during operation of the Power Station is supported. In this case
fully charge the battery of the Power Station at least once in a month in or-
der to extend battery life span.
The battery can be charged in different ways:
• with adapter from public supply or generator (alternating current)
• with PV-panels (additional equipment)
• with cigarette-plug of a vehicle
• with generator
► Completely charge battery prior to operation.
► Use original adapter and cables only.
The battery supports charging at the AC-input and the DC-input simultane-
ously.
Charge
Make sure that the Power Station is switched off.

► Connect Adapter to the Power Station and the alternating current sock-
et.
A generator may also be used as power source.

► Actuate main on/off switch to start charging the battery of the Power
Station.
The battery is beeing charged.

Stop charging
When the battery is fully charged, charging will stop automatically.

Battery is fully charged.

► Disconnect cabel.
Plug and play charging with PV-panels . As soon as the PV-panels are

connected, charging starts and ends automatically.
The Power Station does not have to be switched on for charging.

Charge
► Connect adapter cable to the Power Station.
► Connect the PV-panels to the adapter cable.
► Actuate settings switch to change to the settings overview screen.
► Set the direct current input to PV.
The battery is beeing charged.

Stop charging
When the battery is fully charged, charging will stop automatically.
