Initial Operation; Cleaning - Scheppach 5906218901 Original Bedienungsanleitung

Mixture 2- stroke - oil
0,025 l
0,05 l
1:40
0,075 l
0,1 l
9.

Initial operation

Starting the engine
• Before starting , ensure that no applicance has been
connected to the generator .
• Open the petrol cock (5a) by turning it down
• Move the ON/OFF switch (5) to position "I" with the
key.
• Move the choke lever (3) to position "START".
• Start the engine with the reversing starter (4) by pull-
ing the handle forcefully. Return the reversing starter
gently and slowly to the original position by hand. If
the engine does not start, pull the handle again.
• Note: when the motor is started for the very first
time. It will require a number of attempts to start until
the fuel has travelled from the tank to the motor.
• Push the choke lever (3) back again after the engine
has started. (RUN)
Important: This socket may be loaded continuously
(S1) with 650W and temporarily (S2) for a maximum of
2 minutes with 700W.
• The generator is suitable for 230 V~ a.c. appliances.
• Do not connect the generator to the household net-
work as this may result in damage to the generator
itself or to other electrical appliances in your home.
Note: Some electrical appliances (power jigsaws,
drills, etc.) may have a higher level of power consump-
tion when used in difficult conditions.
Switching off the engine
• Before you switch off the generator, allow it to run
briefly with no consumers so that it can "cool down"
• Move the ON/OFF switch (5) to position "O" with the
key.
• Close the petrol cock
24 | GB
Regular unleaded
Petrol
1l
2l
3l
4l
www.scheppach.com
Important: The generator is equipped with an over-
load cut-out.
This shuts down the socket (7). You can reactivate the
socket (6) by pressing the overload cut-out (7).
Important! If this happens, reduce the electric
power you are taking from the generator or remove
any defective connected appliances.

10. Cleaning

Caution!
Switch off the motor and pull the spark plug boot from
the spark plug before doing any cleaning and mainte-
nance work on the equipment.
We recommend that you clean the equipment immedi-
ately after you use it.
Machine
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible. Wipe
the equipment with a clean cloth or blow it with com-
pressed air at low pressure.
• We recommend that you clean the device immedi-
ately each time you have finished using it.
• Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the
device.
Air filter (fig.6)
• The air filter should be cleaned after every 30 hours
of operation.
• Remove the air filter cover (8).
• Remove the filter element (7a).
• Clean the filter element with soapy water, rinse with
clear water and leave to dry well before reinstalling.
• Assemble in reverse order
Spark plug (fig.8 + 9)
Check the spark plug for dirt and grime after 10 hours
of operation and if necessary clean with a copper wire
brush. Thereafter service the spark plug after every 50
hours of operation.
• Remove the spark plug cap (8a).
• Clean any dirt from around the spark plug base.
• Use the wrench to remove the spark plug.