Installation Steps Without Cpl Filter - Rollei F:X Pro Filterhalter Mark III 100 mm Anleitung

10

Installation Steps without CPL Filter

1
1. Screw the base ring with the CPL filter onto the
camera lens. Use an adapter ring if necessary.
2. Place the filter holder on the base ring. Hook it on
one side and press the orange easy lock button on
the other side. The filter holder locks onto the base
ring.
ENGLISH
2
Note:
– The filter holder can be used only with square filters
with a width of 100 mm and a thickness of 2 mm.
– The filter holder and the adapter ring are made of
aluminum. Therefore, minor friction noises under
rotation are normal. This does not affect the perfor-
mance of the filter holder or the filter itself.
– A maximum of one round filter and two square
filters can be used at the same time. With two
extension rails (optionally available), another filter
can be used.
– If the filter holder is installed correctly, the filter
can be inserted from the top or bottom. In addition
the system can be rotated.