Auto/Manual Scan & Station Storage In Fm, Mw And Sw Modes; Manual Scanning; Channel Selection - Raddy Rf750 Bedienungsanleitung

SW frequency range: 5.70-17.9MHz
WB frequency range: 162.400-162.550MHz
When listening to FM, SW and WB bands, please pull up the telescopic
antenna.
Band switching: In the state of power on, short press the [BAND]
5.1
key to switch between MW / FM / SW / WB bands.
Auto/Manual Scan & Station storage in FM, MW and SW modes:
5.2
5.2.1 Auto scan and station storage: In the state of power on, In
MW / FM / SW band, short press
indicator light on, press and hold
" "indicator light flashing, means that the
full-automatic scan and storage radio station is started, and
the station will scan from the low to high, high to end
frequency. After completing a scanning circle, it will
automatically stop and play the first saved station.
MW (Medium wave) channel capacity: 20;
FM channel capacity: 20;
Seven meter waves in short wave, and each meter wave
can store 10 (total: 110).

5.2.2 Manual scanning:

In the radio working mode, slide the coding pulley switch on
the right side to find the active radio station with "
signal indicator light on.

5.3 Channel Selection

According to the operation in 5.2.1, after performing a channel
scan, you can press "
saved channel. The 1-7 number indicator lights up accordingly.
If more than 7 are stored, the indicator light combination is on：
For example, Memory 8 is: Light 1 + Light 2 are on for 1 second at
the same time,
RF750 Portable Shortwave Radio
"or " " button to select a previously
06
button radio "
button for two seconds,
"
"