Ego Power+ STX3800 Übersetzung Der Originalanleitung Seite 7

SPECIFICATIONS
Voltage
No-load Speed
Cutting Mechanism
Cutting Line Type
Cutting Width
Recommended Operating
Temperature
Recommended Storage Temperature -20°C-70°C
Optimum Charging Temperature
Weight (without battery pack)
Measured sound power level L
Sound pressure level at operator's
ear L
PA
Guaranteed sound power level L
(measured according to 2000/14/EC)
Front-assist
handle
Valuation of
vibration a
h:
Rear handle
◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
NOTICE:
The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used; In order to protect the operator, user should wear
gloves and ear protectors in the actual conditions of use.
PACKING LIST (FIG.A1)
DESCRIPTION
KNOW YOUR LINE TRIMMER (Fig. A1)
1. Socket
2. Lock-off Lever
3. Threshold Ring
4. Loop handle
5. Trimmer Line
56 V
Up to 5800 /min
Bump Head
3.0mm nylon
twist line
38 cm
0°C-40°C
5°C-40°C
5.8 kg
94.2 dB(A)
K=1.8 dB(A)
WA
74.15 dB(A)
K=2.5 dB(A)
96 dB(A)
WA
3.2 m/s
2
K=1,5 m/s
2
2.3 m/s
2
K=1.5 m/s
2
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — STX3800
6. Guard Assembly
7. Shaft
8. Trigger
9. Rear handle
10. Trimmer Head(Bump head)
11. Release tab
12. Line-cutting blade
13. Safety barrier bar (For brush cutter head only)
14. Locking pole for safety barrier bar (For brush cutter
head only)
15. Out flange (For brush cutter head only)
16. Nut (For brush cutter head only)
17. Screw
18. Allen key
19.Nut
ASSEMBLY
WARNING: If any parts are damaged or missing,
do not operate this product until the parts are
replaced. Use of this product with damaged or missing
parts could result in serious personal injury.
WARNING: Do not attempt to modify this product
or create accessories not recommended for use with
this Line trimmer. Any such alteration or modification
is misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING: To prevent accidental starting that
could cause serious personal injury, always unplug the
battery connector from the socket when assembling
parts.
WARNING: When the tool is equipped with brush
cutter head, the safety barrier bar should be mounted.
MOUNTING THE GUARD
WARNING: Always wear gloves when mounting
or replacing the guard. Take care of the blade on the
guard and protect your hand from cutting.
WARNING: Never operate the tool without the
guard firmly in place. The guard must always be on
the tool to protect the user! When the guard is fixed,
never attempt to remove or adjust the guard, if a
replacement is needed, it should be performed by a
qualified service technician!
EN
7