Silverline 953705 Bedienungsanleitung Seite 11

Troubleshooting
Problem
Red LED (15) on the Battery Charger (14) does not
illuminate to indicate the Battery (6) is correctly charging
Battery pack has low capacity
Tool does not start when ON/OFF Switch turned on
Slow material removal
Scratches on workpiece after sanding
Burn marks on workpiece
Excessive dust emission
Possible cause
Battery not correctly connected to Battery Charger
Battery Charger not powered
Battery not being fully charged
Battery pack has been charged over 100 times and capacity has started
to reduce
Battery completely discharged
Defective Battery
Tool defective
Sanding disc too fin or worn
Sanding Disc too coarse
Not enough material removed
Sanding disc incompatible with material
Too much pressure exerted on to the sander
Dust extraction not working; Sanding Disc not aligned with dust
extraction holes in the Sanding Pad (12); extraction holes blocked
Dust Bag (7) full
Dust Bag insufficien for the task at hand
18V Random Orbit Sander 125mm
Solution
Clean battery socket of Battery Charger and Battery contacts and fully
slide on to Battery Charger so it clicks in a locked position
Recheck mains connection
Do not remove Battery until a full charge is indicated
This is normal for battery packs. Contact your Silverline dealer to
purchase a replacement battery pack
Recharge Battery or replace with a fully charged Battery
Replace Battery
Contact your dealer or authorised Silverline service centre
Fit new Sanding Disc with coarser grit
Fit new Sanding Disc with fine grit
Continue sanding
Fit correct Sanding Disc
Use less pressure whilst moving the machine
Realign Sanding Disc; unblock dust extraction holes
Empty Dust Bag
Connect a vacuum dust extraction system
silverlinetools.com
11