Temperature Indicator; Accessories - Sharp SJ-BA34CHXIE-EU Bedienungsanleitung

CHAPTER -3: USING YOUR FRIDGE FREEZER
• Your fridge is designed to operate in the ambient temperature intervals stated in the standards, according to
the climate class stated in the information label. We do not recommend operating your fridge out of the stated
temperatures value limits in terms of cooling effectiveness.
• This appliance is designed for use at an ambient temperature within the 10°C - 43°C range.
Climate class and meaning:
T (tropical): This refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to 43 °C.
ST (subtropical): This refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to
38 °C.
N (temperate): This refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to
32 °C.
SN (extended temperate): This refrigerating appliance is intended to be used at ambient temperatures ranging from
10 °C to 32 °C.

Temperature indicator

In order to help you better set your refrigerator, we have equipped it with a temperature indicator located in
the coldest area.
To better store the food in your refrigerator, especially in the coldest area, make sure the message "OK"
appears on the temperature indicator. If "OK" does not appear, this means that the temperature setting has
not been done properly.
Since "OK" appears in black, it will be difficult to see this indication if the temperature indicator is badly lit. To
be able to see this indication properly, there should be enough light.
Each time the temperature setting device is changed, wait for the stabilisation of the temperature inside the appliance
before proceeding, if necessary, with a new temperature setting. Please change the position of the temperature setting
device progressively and wait at least 12 hours before starting a new check and potential change.
NOTE: Following repeated openings (or prolonged opening) of the door or after putting fresh food into the appliance, it
is normal for the indication "OK" not to appear in the temperature setting indicator. If there is an abnormal ice crystals
build-up (bottom wall of the appliance) on the refrigerator compartment evaporator (overloaded appliance, high room
temperature, frequent door openings), set the temperature setting device to a lower position until compressor off
periods are obtained again.
Putting food in the coldest area of the refrigerator
Your foods will be better stored if you put them in the most appropriate
cooling area. The coldest area is just above the crisper.
The following symbol indicates the coldest area of your refrigerator.
To ensure a low temperature in this area, make sure the shelf is located at
the the same level as this symbol, as shown in the illustration.
The upper limit of the coldest area is indicated by the lower side of the sticker (head of
the arrow). The coldest area upper shelf must be at the same level with the arrow head.
The coldest area is below this level.
As these shelves are removable, make sure they are always at the same level with these
zone limits described on the stickers, in order to guarantee temperatures in this area.

Accessories

Icematic (In some models)
• Take out the ice making tray
• Fill the water to the line.
• Place the ice making tray in its original position
• When ice cubes are formed, twist the lever to drop ice cubes into the icebox.
Note:
• Do not fill the icebox with water in order to make ice. It may be broken.
• The movement of the ice maker may be difficult while the refrigerator is running. In
such a case, it should be cleaned after removing the glass shelves.
Ice tray (In some models)
• Fill the ice tray with water and place in freezer compartment.
• After the water completely turned into ice, you can twist the tray as shown below to get the ice cube.
EN -12-
OK