Installation Steps - Pkm S3-60 ABTZ Bedienungsanleitung

9. When an exhaust duct is used, the ending of the exhaust hose must be adjusted
into the direction of flow.
10. If the exhaust duct passes through cool areas (e.g. an attic), a temperature gradient
may occur in the different parts of the exhaust duct so condensate will be
generated. Proper insulation of the corresponding parts of the exhaust duct will
then be needed. Equip such an exhaust duct with a condensate trap if need be.
11. Depending on the model, the hood is equipped with one (top) or two (top,
back) outlets.
12. The idle outlet is covered by a plastic cap. You can remove this cap by turning it
anticlockwise. Use the cap to cover the idle outlet.

2.3 Installation steps

WARNING! Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
WARNING! Do not damage the wiring in the wall while drilling.
NOTICE! At least one assistant is required for installation.
Please fix the damper flap on the air outlet before installation
1. Find a suitable position for the appliance. Drill four Ø 8 mm holes in the wall
using the stencil. Fix the top expanding plugs and screws in the holes. The screw
heads must have a distance of 10 mm to the wall (see also item 2). Also insert the
bottom expanding plugs.
34