Specifications - Makita DJV141 Betriebsanleitung

ENGLISH (Original instructions)
1. Red indicator
2. Button
3. Battery cartridge
4. Star marking
5. Cutting action changing lever
6. Lock switch
7. ON/standby switch
8. Lock-off
9. ON
10. Standby
11. Speed adjusting dial
12. Fixed position

SPECIFICATIONS

Length of stroke
Max. cutting capacities
Strokes per minute (min
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for the sawing of wood, plastic and
metal materials. As a result of the extensive accessory
and saw blade program, the tool can be used for many
purposes and is very well suited for curved or circular
cuts.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS JIG SAW SAFETY
WARNINGS
1. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
6
Explanation of general view
13. Released position
14. Jig saw blade
15. Base
16. Hex wrench
17. Cover plate
18. Anti-splintering device
19. Dust nozzle
20. Clamp screw
21. Hose for vacuum cleaner
22. Cutting line
23. Bolt
24. Bevel slot
Model
-1
)
Overall length
Net weight
Rated voltage
Wood
Mild steel
Aluminum
800 - 3,500
D.C. 14.4 V
2. Use clamps or another practical way to secure and
ENE019-1
support the workpiece to a stable platform. Holding
the work by hand or against your body leaves it
unstable and may lead to loss of control.
3. Always use safety glasses or goggles. Ordinary
eye or sun glasses are NOT safety glasses.
4. Avoid cutting nails. Inspect workpiece for any
nails and remove them before operation.
5. Do not cut oversize workpiece.
GEA010-1
6. Check for the proper clearance beyond the
workpiece before cutting so that the blade will not
strike the floor, workbench, etc.
7. Hold the tool firmly.
8. Make sure the blade is not contacting the
workpiece before the switch is turned on.
9. Keep hands away from moving parts.
10. Do not leave the tool running. Operate the tool
only when hand-held.
11. Always switch off and wait for the blade to come
to a complete stop before removing the blade from
the workpiece.
GEB045-2
12. Do not touch the blade or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
13. Do not operate the tool at no-load unnecessarily.
14. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation and
skin contact. Follow material supplier safety data.
25. Graduations
26. V-notch
27. Gear housing
28. Starting hole
29. Rip fence
30. Fence guide
31. Threaded knob
32. Circular guide pin
33. Ruler bar
34. Guide rail adapter
35. Screw
36. Guide rail
DJV141
26 mm
135 mm
10 mm
20 mm
280 mm
2.4 kg
DJV181
26 mm
135 mm
10 mm
20 mm
800 - 3,500
298 mm
2.5 kg
D.C. 18 V