Intended Use; Power Supply - Makita M2402 Betriebsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Wheel diameter
Max. wheel thickness
Hole diameter
No load speed
Dimensions
(L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014

Intended use

The tool is intended for cutting in ferrous materials with
appropriate abrasive cut-off wheel. Follow all laws and
regulations regarding dust and work area health and
safety in your country.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution
systems of between 220 V and 250 V
Switching operations of electric apparatus cause volt-
age fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.25 Ohms it can be pre-
sumed that there will be no negative effects. The mains
socket used for this device must be protected with a
fuse or protective circuit breaker having slow tripping
characteristics.
Model with front cover type safety
guard + 97.0 mm height base
Model with front cover type safety
guard + 77.0 mm height base
Model with center cap type safety guard
Model with front cover type safety
guard + 97.0 mm height base
Model with front cover type safety
guard + 77.0 mm height base
Model with center cap type safety guard
M2402
3,800 min
No load speed differs from country to country. Refer to the nameplate on the tool.
500 mm x 280 mm x 630 mm
490 mm x 280 mm x 610 mm
490 mm x 280 mm x 610 mm
15.5 kg
14.5 kg
14.0 kg
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-3-10:
Model M2402
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3.0 dB(A)
Model M2403
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3.0 dB(A)
NOTE: The declared noise emission value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may
also be used in a preliminary assessment of exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
6 ENGLISH
M2403
355 mm
3 mm
25.4 mm
-1 -1
or 3,900 min
515 mm x 280 mm x 640 mm
500 mm x 280 mm x 620 mm
500 mm x 280 mm x 620 mm
15.3 kg
14.3 kg
13.8 kg
/II
) : 98 dB(A)
pA
) : 108 dB (A)
WA
) : 99 dB(A)
pA
) : 109 dB (A)
WA