Frequently Asked Question; Lighting Instructions; Care And Cleaning - RUSTA EXPERT Gebrauchsanweisung

BURNERS

FREQUENTLY ASKED QUESTION

Why is there no seal between the burner and valve?
Answer: In order for the gas to get the right combustion at the burner, it must be mixed
with oxygen. This happens in the joint between the valve and the burner. The joint must
not be sealed. If you do, the combustion will deteriorate.

LIGHTING INSTRUCTIONS

1. Open the hood and make sure all the burners are in the off position.
2. Connect the regulator to the gas cylinder. Open the gas cylinder's valve to release the gas.
3. Press any of the knobs with a lightning symbol on the barbecue and turn anticlockwise
towards the HI position. This releases the gas and generates a spark.
4. If the burner does not light within 5 seconds, turn the knob to the closed position and
close the valve on the gas cylinder. Wait 3 minutes, and then redo steps 2 and 3.
5. Once the barbecue is lit, repeat steps 2 and 3 for the barbecue's other main burners.
6. Close the lid of the barbecue and allow it to reach the desired temperature.
7. Turn the knob between HI and LO to adjust the heat.
8. To switch it off, turn the gas cylinder's valve to the closed position and then turn the
knob on the barbecue clockwise to the closed position.

CARE AND CLEANING

• Allow the barbecue and all parts to cool fully before cleaning them.
• Check to make sure the fuel supply from the LPG cylinder has been turned off.
• The grease/oils that collect in the bottom of the barbecue, the drip plate and heat
distributors must be cleaned from the barbecue regularly, otherwise there is a
significant risk of the fat catching fire.
• Clean the interior and exterior of the barbecue and the drip plate thoroughly and regularly.
• If the barbecue is used in especially corrosive environments, for example, by the sea,
it is even more important to clean the barbecue often. Salt and moisture will break
down the protective outer layer of the barbecue, which can result in surface rust.
6
Valve
Oxygen
Burner hose
Gas