Time Display - Beko HTV 8716 DSW BTR Bedienungsanleitung

5.12.3 Extra Dry
Drying continues until the drying level reaches
the Cupboard Extra Dry step.
C
INFORMATION
• The dryness level might change depending
on the mix of laundry, type of material,
amount and wetness level of the laundry.
• Do not use the machine to dry laundry that
contains lace, tulle, bling, beads, paillette,
wire etc. or laundry with high silk content.
5.12.4 Time based
drying - minutes
You can select 30, 90 or 150 minutes drying
to reach the desired dryness level at a low
temperature.
C
INFORMATION
• When drying small amount of laundry (2
pieces maximum), select the timed drying
steps in the Cottons or Synthetics drying
programmes.
• If the laundry has not reached the desired
dryness level at the end of the drying
programme, you can select timed drying to
end the process.
• When this function is selected, the machine
performs drying for the adjusted time
irrespective of the drying level.

5.13 Time display

While the programme is running, the time
remaining to the end of the programme will be
displayed in hours and minutes, e.g. "01:30".
C
INFORMATION
• Programme time may differ from the values
in section "Programme and consumption
table" depending on the water pressure,
water hardness and temperature, ambient
temperature, amount and the type of
laundry, auxiliary functions selected and the
changes in the mains voltage.
30 / EN
5.14 End Time
With the End Time function, start of the
programme can be delayed up to 24 hours.
After pressing the End Time button, the
programme's estimated end time will be
displayed. If an End Time is set, the End Time
light will turn on.
To ensure that the End Time function is enabled
and the programme ends at the end of the
defined duration, you should press Start /
Pause after setting the duration. The Start/
Pause button will stop flashing and remain on.
If you want to cancel End Time function, press
the End Time button until the End Time light
turns off or press the On/Off button to turn off
and on the machine.
1. Open the loading door, place the
laundry and add detergent, etc.
2. Select the washing programme,
temperature, spin speed and, if
required, the auxiliary functions.
3. Press the End Time button to set the desired
end time. The End Time light will turn on.
4. Press the Start / Pause button. Countdown
will start. ":" sign in the middle of the end
time on the display will start flashing.
C
INFORMATION
• Do not use liquid detergents when you
enable the End Time function! Stains might
remain on the clothes.
• The door will remain locked during the End
Time countdown. If you want to unlock
the door, press the programme start/
pause button to switch the machine to
pause mode. At the end of the countdown,
End Time indicator turns off, washing
cycle starts and the time of the selected
programme appears on the display.
• When End Time is selected, the time
displayed on the screen consists of the
end time plus the duration of the selected
programme.
-
Washer-Dryer / User Manual