Napoleon BIPRO 665-3 Anleitung Seite 16

16
Problem
Pilot will not light.
EN
(if equipped)
Illumination and Side/
Rear burner ignition do
not work
Ignitor, oven and cabinet
lights work but the knob
lights don't illuminate
when turning the power
switch ON
Illumination of the knob
and switch lights work
fine, but the side/rear
burner ignition does not
work
Illumination but can't
ignite the side or rear
burner, even when
sparking noise occurs
The knob and switch
lights blink eight times
with 0.5 seconds intervals
and then turn off.
www.napoleon.com
Possible Causes
Lack of gas.
Obstruction in pilot orifice.
Electrode wire loose or off.
Dirty pilot electrode.
Pilot is actually lit.
Electric Power is out
The grill is nor receiving electric power
The motion sensor detector does not work
properly
The wire harness does not work properly
The ignitor switch does not work properly
The ignitor block does not work properly
The gap between electrodes is too big or
too small
The batteries are low
Solution
After turning pilot knob to high, wait
approximately 20-30 seconds for air to purge
the gas supply line while pressing igniter. Fill
propane cylinder. During initial set-up or
after tank has been refilled, it is best to light
one of the tube burners before lighting the
pilot burner. This enables the gas to reach
the valves on the manifold more quickly.
Clean pilot orifice.
Replace lead wire.
Clean pilot electrode.
The pilot flame, especially on natural gas
units is very difficult to see. Place your hand
1 in. (2.5 cm) above grill surface over the
pilot burner to feel for heat.
Check the power outage in your area
Ensure the grill is connected between the
wall and the power bar of the grill
Ensure the red indicator is ON in the control
box
Check if the fuse on the wire in the cabinet is
broken or not
Ensure the blue indicator is ON
Turn the sensor ON by clicking the motion
detector button
If blue indicator is ON, replace the motion
sensor
Replace the wire harness of the control panel
Replace the ignitor switch if the switch light
illuminates when you turn the light switch on
Check the switch connection inside the
control panel If there's no light on the switch
when you turn it on.
Replace the ignitor block if the switch
illuminates and sparking noise can be heard.
Adjust the gap between two prongs of the
side burner electrode when the side burner
does not ignite.
Adjust the gap between the electrode and
the rear burner when the rear burner when
the rear burner foes not ignite
Replace the batteries
N415-0542CE-GB-DE FEB 01.22