Eldom spin SI1050 Bedienungsanleitung Seite 12

Hot-chocolate preparation
Place the tank (5) in the base (8).
•
Install the required tip inside the tank (5).
•
• Pour milk into the tank in the volume not exceeding the maximum level -
Press the button (8) once. Then add the powdered chocolate or the finely crushed solid
•
chocolate.
• Place the lid (1) with the sealing gasket.
Press the button (8) three times. The control light
•
will start.
• The appliance will switch off automatically, and the control light will go off. The appliance
may be turned off at any time with the button (8).
Then remove the lid (1).
•
While holding the appliance by the handle (3), remove the tank (5) from the base and
•
pour out the milk to a cup.
NOTE. The solid chocolate must be finely crushed (preferably grated or blended).
Too-large pieces can block the attachment (2).
After use, wait for about 2 minutes for the thermostat to reset. This time may be shortened
when cold water is poured into the tank. Dry clean the appliance before its use.
CLEANING AND MAINTENANCE
• Clean the appliance immediately after use and cooling down.
• Before cleaning, turn off the appliance with the button (8), disconnect from the power
supply and wait to cool down.
Never immerse the base (6) in water, and do not rinse under running water.
•
• The external surfaces may be cleaned with a damp cloth.
Wash the elements (1), (2) in warm water with addition of washdish, use a soft sponge
•
and rinse under running water.
• Do not use abrasive agents, cleaning powders, acetone, alcohol, etc.
• The elements (1), (4) may be washed in a dishwasher, placed on the upper shelf.
Make sure that they are placed away from the heating element. The maximum
temperature is 50°C.
ENVIRONMENT PROTECTION
• the device is made of materials which can be reused or recycled.
• the device should be handled to a special point which deals with collecting and recycling
of electric and electronic equipment.
GUARANTEE
• the device is designed to be used in households.
• not for professional use.
• the control lamp is not subject to guarantee.
• the guarantee expires when device is used improperly.
12 EN
will go on and the heating process