BDS Maschinen MAB 500 Bedienungsanleitung Seite 24

www.bds-maschinen.de www.bds-maschinen.de www.bds-maschinen.de
23
Thermal protection:
The thermal protection automatically switches the motor off in case of
overheating. Then let the motor run at high speed and no load for about
2 minutes in order to cool down.
Torque setting:
Torque setting can be electronically controlled by means of the rotary
switch Power. If the setting is reduced, the machine will switch off in
the case of increased load. It is recommended to test this during the
first applications so that drill breakage is avoided is the user is
unskilled.
After switching-off, key 0 on the motor switch must be actuated first,
and then key I in order to start the machine again.
Switch the motor on
Press on I of the Motor switch.
Drilling:
Drilling with core drills does not require any great expenditure of force.
Drill without great pressure.
Make sure that the chips are removed upwards.
Please, break the chip in case of greater drilling depths.
A greater pressure does not speed up drilling, the drilling machine will
be worn out quicker and the machine will be overloaded.
Always use cooling lubricating device, which is part of the delivery.
The service life of the tool depends on the lubrication!
Permanent internal lubrication with high performance cutting oil BDS
5000 is a must.
info@bds-maschinen.de info@bds-maschinen.de info@bds-maschinen.de