Additional Safety Instructions - BDS Maschinen MAB 500 Bedienungsanleitung

www.bds-maschinen.de www.bds-maschinen.de www.bds-maschinen.de

3. Additional safety instructions

−
Carefully read the directions for use before you start working with
the machine
−
Always use safety goggles in order to avoid eye injury
−
The machine is very loud. Please use ear protection
−
Use a safety helmet in case of overhead work
−
Disconnect the machine from the mains before you change the
tool. Caution: Then the power supply to the magnet is also
disconnected
−
Secure the machine with the enclosed chain when working
−
−
−
Always wear safety harness when working on a scaffold
In the case of an interruption of the power supply, the machine
oscillates dangerously.
The power supply to the magnet is also disconnected
−
Always see that the main supply line is not damaged
−
The magnet causes magnetic and electromagnetic fields which
may have an adverse effect on medical implants
−
The surface for the electromagnet must always be clean and plain
−
The magnetic adhesion depends on the material's thickness and
condition
−
Layers of lacquers, zinc and scale will reduce the magnetic
adhesion
−
For overhead work only use BDS ZHS 400 high-performance
lubrication spray. Normal cutting oils used for overhead work
could run into the motor and cause a short-circuit
info@bds-maschinen.de info@bds-maschinen.de info@bds-maschinen.de
on bevelled or vertical surfaces or
overhead
18