BOMANN WA 7170.1 Bedienungsanleitung, Garantie Seite 29

NOTE:
 Always add the detergent powder just before
starting the wash cycle, otherwise it could get
damp and will not dissolve properly.
 At the end of the wash cycle the drawer must be
empty.
I. Chamber for pre-wash detergent.
II. Chamber for main wash detergent.
Chamber for detergent additive (softener). Do not
exceed the MAX mark!
Positioning the separator in the main wash chamber
(a)
When using detergent powder:
(a) Position the separator A in the upper position of
the guide rail C.
 Lift the separator (1) until it can be reclined (2).
 Place the hook B on the rear guide rail and push
the partition slightly downwards (3) to fix it.
 If the separator is correctly positioned, there will
be a gap between it and the chamber bottom.
When using liquid detergent:
(b) Position the separator A in the lowest position of
the guide rail C.
 Fix the separator with the front guide rails. Set up
the separator so that it touches the chamber bot-
tom.
(b)
29
Foam detection
Excessive foam forms when too much detergent is
used. This affects the wash and rinse cycle. The
function automatically checks foaming; excessive
foam is removed by an extra rinse and spin cycle.
Fill in the laundry
 Unravel the clothes before putting them into the
machine.
 Each load should correspond to the nominal ca-
pacity of the appliance. Do not overload the appli-
ance. Different strengths, sizes and types of laun-
dry can affect the actual loading capacity. It is ad-
visable to load the appliance just that a normal
circulation during washing is possible.
 Make sure that no laundries are caught between
the appliance door.